Hello everyone
CUH-1004a (firmware 5.01) after replacing the HDD, only the recovery starts and asks for an update. At first, when updating, there was error 42118-6 (I replaced the drive cable). Now error 35888-2. The drive itself reads disks (it normally receives / sends, the motor is spinning). The bdp-025 drive board noticed when reading the disk that the Renesas chip heats up very quickly and becomes hot (the hand does not tolerate it) - does this mean that it is dead?
In connection with this problem, I ask knowledgeable people to answer the following questions:
1. Is there a way to update PS 4 Fat with firmware 5.01. from the Recovery menu with a non-working blur drive?
2. Does anyone have a schematic diagram of the components of the bdp-025 driver's blade? I want to diagnose her for a short circuit.
Thank you all who responded!Peace!
CUH-1004a (firmware 5.01) after replacing the HDD, only the recovery starts and asks for an update. At first, when updating, there was error 42118-6 (I replaced the drive cable). Now error 35888-2. The drive itself reads disks (it normally receives / sends, the motor is spinning). The bdp-025 drive board noticed when reading the disk that the Renesas chip heats up very quickly and becomes hot (the hand does not tolerate it) - does this mean that it is dead?
In connection with this problem, I ask knowledgeable people to answer the following questions:
1. Is there a way to update PS 4 Fat with firmware 5.01. from the Recovery menu with a non-working blur drive?
2. Does anyone have a schematic diagram of the components of the bdp-025 driver's blade? I want to diagnose her for a short circuit.
Thank you all who responded!Peace!